You will then see a menu where you can edit the connection properties. Select the interface to which you would like to assign a static IP address. From Control Panel, select “Network” as shown below: Network on Control Panelįrom within network settings, navigate to the tab “Network Interface” where you should see a list of your network interfaces. In order to setup a static IP address, first login to DSM and open up the Control Panel. If you do decide to change your network’s subnet, just be sure to enable DHCP first. It tends to be an issue primarily with mobile devices such as laptops, which will be connecting to many different network setups. The second case is not likely to cause an issue unless you decide to change your router’s subnet. Most routers will allow you to setup your network like this, and it is most likely under “DHCP” in your routers settings. The way that I do this is I set my router to give away addresses between 192.169.1.2-192.168.1.100, and then I set my static IP address above 192.168.1.100. To combat the first case, you should set your router never to give away the IP you will be setting. The router has given the IP address away to another device that DSM is requesting.There are two possible reasons why it would not be available: Static IP addresses are easy to setup, however they can cause issues if the IP address you choose is not available on the network. ![]() DHCP reservations are setup via your router and will be the subject of a future tutorial. This tutorial will show you how to do the setup through the NAS itself. There are two different ways to get a static IP address from your router: either through the NAS itself or using DHCP reservations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |